Laptop stand height calculator: how many inches of lift do you need?

As an Amazon Associate I earn from qualifying purchases. Some links on this page are affiliate links — if you buy through them, we may earn a commission at no extra cost to you. Disclosure

Stands by published lift

OSHA's rule is "the top of the monitor should be at or slightly below eye level." This calculator works out where your eyes are and where the top of the laptop screen is with the laptop flat on the desk. The gap between the two is the lift your stand needs. A measured eye height is the primary input. Every assumption is shown and can be changed.

Your eye height

The most accurate figure is one you measure: sit or stand the way you work and measure from the floor to the outer corner of your eye. Your height is used only if you leave that box blank, and the result is then labeled an estimate.

Posture (used only for the estimate)

Desk and laptop
Assumptions (editable)

Side view: the top of the screen at or slightly below eye level, the screen center 15 to 20 degrees below the eye line, 20 to 40 inches away eye level 15–20° to screen center top at orjust below 20–40 in (OSHA)

How it works

  1. Target. The top of the screen sits at your eye height minus the screen-top drop. The default drop is 1 in (you can set 0–3 in), following the OSHA Computer Workstations eTool: "the top of the monitor should be at or slightly below eye level." OSHA doesn't give a number for "slightly," so the 1 in is our assumption. The same OSHA page also says the center of the screen should normally be 15 to 20 degrees below horizontal eye level, at a preferred viewing distance of 20 to 40 inches. The result shows the angle to the screen center next to that 15–20° guide. On a small laptop screen, both conditions may not be met at once: lowering the top to deepen the center angle, or raising it to keep the top near eye level, pulls the other figure the other way.
  2. Eye height. A measurement you enter always wins and needs no formula. Without one, the seated figure is an estimate: 0.701 × your height, plus the shoe allowance (default 1 in). We derived 0.701 from the ANSUR II public body measurements (US Army, 2012) as (popliteal height + sitting eye height) ÷ stature, barefoot. The sample is 6,068 adults (4,082 men, mean 0.703; 1,986 women, mean 0.698). The 5th–95th percentile range of that ratio is 0.684–0.717. Seat height is taken as popliteal height — the assumption is that the chair is set so the seat meets the back of the knee. This is a military sample, not a civilian office sample, which is one reason the result is labeled an estimate and why a measured eye height is the better input. Standing eye height is 0.936 × your height, plus shoes, from Drillis & Contini, via Winter.
  3. Screen. A 16:10 screen is 0.530 × its diagonal tall. Add the bezel and hinge, tilt the lid back, and add the base: that gives the top of the screen above the desk. Those geometry figures are assumptions and are editable above.
  4. Stands. Each stand's published lift is compared with what you need. Makers measure differently: Roost quotes "screen lift," the others the stand's height, so each row shows its basis. Stands with no published lift are listed as "not published."

Reading the result: most people need more lift than a fixed riser gives, and lifts that high need an external keyboard. Ready-made figures by height, from the same formulas, are in the height chart. The thinking behind the target is in laptop stand ergonomics. Standing at a desk needs more lift — see stands for a standing desk. Ranges side by side are on the adjustable stands page, and typing without a keyboard is covered in laptop stands without an external keyboard.

Published lift or height ranges of 4 stands on a 0 to 13 inch scale 0612 in Rain Design mStand Rain Design iLevel2 Roost V3 BESIGN LS03

The stands with a published lift, at one scale

Each stand seen from the side with the same generic 14-in laptop (not a specific model), drawn to one scale from the makers' lift figures, lowest to highest. Grid lines are 3 in apart. Vertical stands, the folding wedge, the cooling pad and the arms are left out because their makers publish no lift height; their own cards show them.

Laptop stands at one scale: lift heightSide views at one scale, each with the same generic 14-in laptop, lowest lift to highest: BESIGN LS03 lifts 5.7 in; Rain Design mStand lifts 5.9 in, 7.5 in deep; Rain Design iLevel lifts 5.4–7.9 in, 8.8 in deep; Roost V3 lifts 6.5–12.5 in. Vertical stands, the wedge, the cooling pad and the arms are left out: their makers publish no lift height.1 ft3 in6 in9 in12 in15 in18 in21 in24 in5.7 inBESIGNLS03depth not published5.9 inRain DesignmStand5.4–7.9 inRain DesigniLevel6.5–12.5 inRoostV3depth not published
Illustration to scale — not product photos. Lift heights are the makers' figures; where a maker publishes no stand depth (marked under the name), the depth is a placeholder. See how we draw these.

Specs verified: November 2026 · Updated 2026-11-18 · How we research